polo9N.info - polo6R.info Forum

Hi Guys...
can You help me with my question:
it's a problem if i install a 9n tacho with 5500rpm on my polo with 6000rpm??
thank You.

It is not possible to adapt a 9N Tacho in an 9N3

because of this problem or others?

Problem is the Immobilizer

Problem is the Immobilizer

but I will reflash eeprom so i think there is no problem!

It is more than only one difference in the data record. The software in the MCU is different. If you flash a 9N Tacho with data from 9N3 there will not adapt the Immo-Controller (25)

It is more than only one difference in the data record. The software in the MCU is different. If you flash a 9N Tacho with data from 9N3 there will not adapt the Immo-Controller (25)

so it's impossible to adapt a 9n tacho on 9n3?

so it's impossible to adapt a 9n tacho on 9n3?

Yes!

so it's impossible to adapt a 9n tacho on 9n3?

Yes!

and a 9n3 tacho from a 1.9tdi 130cv up to 260 km/h will fit a 9n3 1.9tdi 101 with the Original tacho up to 220km/h? Thank you for your big help!!

With VCDS it is possible…. Volkswagen dealer not necessarily. Please communicate your VIN and the part number of the Tacho

With VCDS it is possible…. Volkswagen dealer not necessarily. Please communicate your VIN and the part number of the Tacho

i haven't yet...i was asking to understand what i have to buy..

Can I adapt a tacho with this tool: VAG DASH COM+CAN (can I link the item auction for example?)
without reading and writing an eeprom??
Thanks.