Back Plate - incident

[VoL]

An Lancia Y has park too much close near my back plate and he folding it !!!

Now I would to repair the plate but, for take the plate and his support i must remove all the rear bumper?

Thank you!!!

[Sylonien]

Do you mean number plate? You can just take it off by pulling on it hard - its just stuck on to the frame, the plastic frame has some 3 screws or so screwed down on to the bumper - don't need to take that off. Although I'm not quite sure what you mean - picture will explain things better.

[me1ssner]

i am not sure that in Italy you can just take it off by pulling on it hard... in germany it is different at many cars. and in italy may be, too.

please make some pictures and we will help you.

[VoL]

Do you mean number plate? You can just take it off by pulling on it hard - its just stuck on to the frame, the plastic frame has some 3 screws or so screwed down on to the bumper - don't need to take that off. Although I'm not quite sure what you mean - picture will explain things better.

yes, I must repair this problem:
http://xoomer.alice.it/nerims/Copia%20di%20DSCN4095.JPG

can someone help me now?

[me1ssner]

there is no photo:

Attenzione, la pagina che cerchi non esiste!

Le strutture dei siti ospitati da Xoom.it possono cambiare per esigenze tecniche o necessità redazionali degli Xoomer.
Continua a cercare sui siti di Xoom.it!

[px]

Eben war da noch eines. Er hat sein Kennzeichen hinten eingedrückt. Allerdings sieht der Halter komisch aus, als wäre das Kennzeichen selbst einfach aufgeklebt oder so. Man erkennt keine Haltepunkte etc.

[VoL]

I can't find a good hoster for the photo.. Sorry!!



http://img525.imageshack.us/img525/411/ ... 095mz3.jpg

[Sylonien]

There are no screws on the plate so surely it must be stuck on using sticky pads on the back - I think you can just pull it off from the look of the picture. That plastic frame around it is screwed down to the bumper - don't need to take that off to replace the number plate.

[VoL]

There are no screws on the plate so surely it must be stuck on using sticky pads on the back - I think you can just pull it off from the look of the picture. That plastic frame around it is screwed down to the bumper - don't need to take that off to replace the number plate.

no no, I have 4 screws (look the photo, this it more clear!!)


who they hold attacked the plate to the "support" but it's damage the plante and also the support, I would tuo repair all two.

>>>>>> I just have ended now!! perfect work, thank you to all for the helps!!!

But I now see an problem... the car who "crash" me have damage the attacks for block the plate light, I must rebuy a new 2

[Sylonien]

Well if there are screws then surely that's what holding them in place?? Why didn't you just take them off then rathering asking here??

Well it looks like you've used some sort of translator which is very difficult to understand. I don't know where its been damaged by the person hitting you at the back - just ask at your local VW dealer if you're unsure if its safe or not - surely they won't charge you just by asking.

[VoL]

[quote="Sylonien"]Well if there are screws then surely that's what holding them in place?? Why didn't you just take them off then rathering asking here??

Excuse me, I wanted to be sure before I probably does a problem.

The photo of the damaged pices.

[gigas19]

you have to just stuck them in again...i had similair problem...

[VoL]

Yes, but the problem for now is that hooks for block the lamp in the bumper are broken. If I re-insert the lamp after remove, the lamp there are not on, it fall down...

Thank you so much

[Sylonien]

Those lamps can be replaced. I had the same problem before - bumped into someone whilst reversing. So I brought some new ones from VW - didn't cost too much - replaced one and brought an extra one. fairly cheap.